Establishing A Bluetooth Connection - Bury technologies CC 9050 Mode D'emploi

Operating guidelines
28
7. Switch-on
If the power supply of the hands-free car kit (HFCK) is connected pro-
perly, the HFCK is activated after having started the ignition. The dis-
play is switched on and a short high sound is audible.
The HFCK now tries to connect automatically to a mobile phone. In the
delivery status an identification of a mobile phone has not been saved.
(cf. chapter: Establishing a Bluetooth connection). The note „empty
list" and then „disconnected" are displayed shortly.
If mobile phones were already connected, the identifications / names of
the mobile phones will appear on the display. These are queried by the
HFCK successively. If no mobile phone was connected to the HFCK
automatically via Bluetooth, a deep sound is audible in regular intervals
indicating this. You can stop this automatic search by pressing key 3.
Display with English menu navigation
In case of a successfully established connection, a long high sound is
audible. The name of the connected mobile phone is displayed and data
from the phone book (SIM-card) and from the address book (telephone
directory) are then transmitted to the HFCK. Depending on the number
of data stored, this could take some seconds. If the synchronisation of
the phone book is interrupted, e.g. by pressing key 3 or by an incoming
call, it may occur that not all entries have been transmitted. In this
case, the phone book should be synchronised manually (cf. chapter:
menu navigation).
Key specifications:
1 = left function key
2 = call answering key
3 = right function key
4 = call termination key
5 = selection key
6 = scroll key (left/top/right/bottom)

8. Establishing a Bluetooth connection

If you wish to establish a Bluetooth connection for the first time, you
have to activate the Bluetooth function of your mobile phone and
search for Bluetooth devices. In this case, search for a device labelled
„CC 9050..." or „CC 9051...". If several devices were identified, please
select the HFCK and enter the PIN number 1234. The Bluetooth con-
nection (pairing) will then be established between your mobile phone
and the HFCK. The HFCK supports the profiles „hands-free operation"
and „A2DP". Please set your mobile phone accordingly or check whe-
ther these profiles are supported.
If it is not possible to establish a connection, please check and update
the software release (firmware) of your mobile phone or of the HFCK.
You will find an overview dealing with this subject on the Internet at
www.bury.com. In addition it is possible that you must delete all de-
vices connected to your mobile phone first in order to enable a correct
identification of the HFCK and the establishment of a connection. If you
have queries regarding the menu navigation, functions and operation of
your mobile phone, please refer to the operating guidelines of your
mobile phone. Depending on the manufacturer and type, this can differ
considerably between phones.
Note:
If the rechargeable battery of the mobile phone is low,

it is sometimes not possible to establish a Bluetooth con-
nection.
The HFCK has a memory for the storage of the identification of up to 10
mobile phones. In case an eleventh mobile phone is connected, the
oldest entry in the HFCK memory will be cancelled. After the commis-
sioning of the HFCK it automatically tries - „hands-free operation" pro-
file - to connect with a mobile telephone already saved.
29
Display with English menu navigation