Bury technologies CC 9050 Mode D'emploi page 14

Installation of the hands-free car kit
24
Example of installation 1:
Example of installation 2:
Step 2:
Depending on the vehicle type and its equipment (e.g. airbags), it is
reasonable to install the microphone either at the A-pillar, at the sun
shield or at the roof interior. For details about the equipment features
please refer to the vehicle documents. Please also observe the notes on
distances to other components and to the driver / speaker, as specified
in the installation manual.
Step 3:
Please lay the cables in a way that they do not lie/hang unsecured in
the vehicle and that they may not influence the conducting of the ve-
hicle. When laying a cable, please take care that it is not under traction
stress but that it has some tolerance. Avoid crushing the cable as da-
mages of the insulation can be caused by friction/rubbing.
Step 4:
Install the electronics box at a convenient place in the vehicle. This can
e.g. be behind the radio, in the glove box, or in the centre console.
Please mind that you can access the connections of the box without
difficulty. Before connecting the components to the electronics box you
should branch off the battery for safety reasons. In doing so, take into
account that there might be a radio coding (confer radio manual).
Important:
Please install the electronics box behind a cover or so-

mewhere you can only reach by opening or unfastening a
protective cover/ a cover. The terminal box must not hang
loosely in the vehicle.
5. Connecting the Electronic box
The power supply of the hands-free car kit is established via a 4-core
cable. Connect the black (clamp 31 – minus), the red (clamp 30 – stea-
dy plus) and the blue cable (clamp 15 – ignition plus) to the power
supply of your radio (where required via the cigarette lighter or the fuse
box). After connection to the counterpart, the yellow cable provides for
radio muting during a phone conversation. Please connect the white
Molex connector with connection 1.
25