Abus TVCC75100 Manuel Utilisateur page 62


65 + preset: "Status Report" is displayed, if user wants to remove this screen, press
Focus Near button.

70 + preset: This feature provides picture stabilization image.
This feature is available only by entering the preset number and is not included in OSD main
menu.

92 + preset: With this feature it is possible to freeze the current picture during tour, auto scan or
pattern operation. When 92 + preset button has been pressed, the image stops but the camera
is still working as per operation such as tour, pattern or auto scan. To return to operating image,
press 92 + preset button again. This feature is available only by enter the preset number and is
not included in OSD main menu.
7.2 Maxpro Protocol
If you want to choose Maxpro Protocol, the user must change the dip switch first.
Baud Rate: 9600 (Maxpro default)
Maxpro protocol is almost same as Pelco D/P protocol operating system but some special features
are different way as noted below:
Quick Operation Key Table 1
Number
1~64,100~200
+Preset
67 +Preset
69 + Preset
80~85 + Preset
86 + Preset
87~89 + Preset
90 + Preset
91 + Preset
92 + Preset
93 + Preset
94 + Preset
95 + Preset
96 + Preset
97 + Preset
98 + Preset
99 + Preset
Quick Operation Keys Table 2:
Use these function keys if controller has these keys
Menu
Tilt Up / Down
Pan Left / Right
Focus Near
Focus Far
Zoom Tele
Zoom Wide
Note
Preset
Auto Flip
DSS
Pattern
Auto Scan
Group Tour
OSD
Zero Position
Freeze
BLC
Day / Night
OSD
Focus Adjust
Vibration Correction
AUX 1
AUX 2
Function
Sub menu cursor moves up / down
Enter to the sub menu or status change or decrement
Using for Enter key when user select YES or NO
Using for function changing keys when set coordinate
Status cursor to the right
Status cursor to the left
Function
Executing Preset 1 ~ 64, 100~200
Selectable On/Off in Auto Flip mode
Selectable On/Off in Digital Slow Shutter
function
Executing Pattern #1 ~ #6
Executing Auto Scan
Executing Group Tour #1 ~ #3
Entering OSD Main Menu
Searching Pan / Tilt Zero Position
Select Freeze image when camera is working
Selectable On/Off in BLC function
Selectable Day / Night / Auto Mode
Entering OSD Main Menu
Focus adjust
Selectable On/Off in Vibration Correction
function
Selectable On/Off in Aux1
Selectable On/Off in Aux2
62