Abus TVCC75100 Manuel Utilisateur page 57

Drilling distances TV7609
Ø35
1. Mark the drill holes with a pen. Note the correct drilling distances. In addition, ensure the drill
holes are horizontally aligned for the goose neck mount bracket (TV7612) exactly.
Remember that the wall or ceiling selected for mounting must be strong enough to bear
loads of up to approx. 6 kg.
2. Use a drill bit with a sufficiently large diameter. Insert suitable wall plugs. Note that the wall
plugs and screws must bear a load of approx. 6 kg. The wall plugs and screws must also be
able to withstand strong drawing forces for the goose neck mount bracket (TV7612).
3. Connect the individual wires together with a cable clip.
4. Depending on the way the cables are laid (flush or surface), the cables can be guided
directly through the retaining plate or through the side cable feed.
5. Screw one of the two threaded rings (included in the indoor adapter's delivery scope) onto
the thread of the goose neck mount/ceiling bracket. Place the indoor adapter on the thread
with the opening facing down and attach the indoor adapter, by screwing the second
threaded ring firmly onto the thread.
6. Use the four screws provided to attach the retaining plate of the mount type (included in the
camera's scope of delivery) to the indoor adapter. To do this, place the mount type plate (in
the camera's delivery scope) on the indoor adapter so that the external drill holes of the plate
are exactly on the four spacer threads of the indoor adapter and screw the four screws in.
7. Screw in the ceiling bracket and the goose neck mount with suitable screws to the
ceiling/wall.
8. Proceed in the same way as in points 6 to 8 on pages 216 and 217.
Ø10
57
Dimensions TV7609