Rehau RAUTOOL M1 Mode D'emploi page 24

6. Select the "compression mode" by moving the button into position
position.
7. Slide the compression sleeve up to the fitting by repeatedly
operating the
ratchet mechanism.
Caution:
Stop the ratchet action as soon as the compression sleeve is in
contact with the fitting! "Over-pressing" of the fitting components
must be avoided! (May result in fitting damage or jamming of the tool)
8. Select the "release mode" by moving the button into its lower posi-
tion (down and to the side).
9. Close the handles again until the locking pawl is released. Then
open the handles fully to their 90° position in order to move the tool
into the initial position.
10. Completed compression sleeve joint.
Processing at temperatures under -10°C and over
+45°C may result in damage to jointing components, to
the tool and/or in personal injury.
- Do not use the tool at temperatures below -10 °C
- At lower temperatures (below 0°C) it is recommended that the
jointing components be stored in a warm environment before
being processed.
24