Table des Matières
Publicité
Communication Fieldbus / Appareil de mesure
Paramètres du bus Standard Transducer Block (TB)
Parameter
Mettler-Specific Parameters – Calibration
30 CALIBRATION_MODE
31 CAL_HIGH
32 CAL_ZERO
33 CAL_SETTLINGTIME
34 CAL_RH
35 CAL_PRESSURE
36 CAL_TEMP
37 CAL_VALUE_SAT
38 CAL_VALUE_CONC
39 CALIBRATION_TIMER
40 CAL_SAMPLE_PRD
41 CAL_SAMPLE_PRD_STORED
_VAL
42 CAL_PRODUCT
98
Description
Sets the calibration mode
The slope of the Oxy electrode in Ampere
The zero offset resulting from a calibration
in Ampere
Shows the settling time in seconds
Shows the relative humidity in %
Shows the pressure
Shows the temperature which was used
during calibration
Shows the value of saturation calibration
Shows the value of concentration
calibration
Sets the calibration timer
(time in which the device should be
calibrated).
Starts the 1st part of Oxy product
calibration.
Shows the stored value of the first step of
Oxy product calibration
Sets the value for the 2nd part of Oxy
product calibration.
Transmetteur O
4100 e FF
2
Publicité
Table des Matières
