Taking Curbs By Using Ramps; Transport In The Car; Installation And Adjustment; Tools - Vermeiren Normandie 2F Mode D'emploi

2.6

Taking curbs by using ramps

L
WARNING:
Risk of tipping over – Never go up or down ramps without the aid of a
helper.
If you are considering the installation of ramps to overcome obstacles, kindly note the
following:
The chair is intended firstly and mostly to be used inside on level and solid surfaces. Never
go up or down ramps that are rough or have bumpy edges, or the comfort chair is not
equipped with four rolling castors. Limit yourself to ascents or descents with a maximum
angle of 6% (3°).
2.7

Transport in the car

L
WARNING:
Risk of injury – See that the chair is attached properly in the car or
the truck.
To transport the comfort chair in the car use following steps:
1. Remove accessories.
2. Store accessories safely.
3. Place the chair in the luggage place.
4. If the chair and the passenger compartment is NOT separated, attach the frame of
the chair securely to the vehicle. You can use the available safety belts in the vehicle.
3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L
WARNING:
Variation of allowed adjustments can still change the stability of your
product (tilt back or sideways).
3.1

Tools

To set up the comfort chair no tools are needed.
3.2

Manner of delivery

The Vermeiren product shall be delivered with:

Frame with seat and backrest cushions

Armrests

Legrest

Gas springs

Manual

Accessories
Before use check if everything is included and that no products are damaged (example by
transport, ...).
Page 11
Normandie 2F
2017-03