Assembly Comfort Chair - Vermeiren Normandie 2F Mode D'emploi

3.3

Assembly comfort chair

Your comfort chair shall be delivered like shown in the figure below. Use instructions below
for the assembly of the comfort chair.
3.3.1 Mounting backrest
For assembly of the backrest, you should lay the model on a flat surface on its side.
Move the backrest backwards until the sockets on the lower back frame and the
A
suspension eye of the pneumatic spring lie over one another.
Guide the locking pin  through the back sockets and the pneumatic spring. Two
B
plastic washers  are to be inserted before and after the pneumatic spring socket as
a spacer guide. Afterwards, secure the locking pin  by guiding the tension spring 
over the pin until it projects out over the end of the spanning pin.
A
B
Page 12
Normandie 2F
2017-03