Belt Tension (For The User); Bearings (Only For Tech Support Service); Drum Pulley And Motor Pulley (For The User) - Kunzle & Tasin Bona Belt Lite Manuel D'utilisation

Routine Maintenance (Cont.)

Belt tension (for the user)

Réglage des roues (suite)

Bearings (only for tech support service)

Réglage des roues (suite)
Check bearings regularly for wear or damage according to the following timescales:
Wheels:
Belt Tightening Pulley:
Fan Shaft:
Tensioning Unit:
Sanding Drum:
Motor Shaft:

Drum pulley and motor pulley (for the user)

Réglage des roues (suite)
Regularly check that the groove (A) of the pulley has not sunk, otherwise the belt (B) will operate on the
bottom (C) of the pulley itself.
Check belt tension regularly.
If the belt is excessively worn it must be replaced.
(For adjustment procedures see page 12 of this manual)
Excessive belt tension may cause the premature failure of the ball bearings. The drum belt must
have a 10.5mm stretch with a center load of 30±3N.
After the first 2500 hours
After the first 2500 hours
After the first 2500 hours
After the first 2500 hours
After the first 5000 hours
After the first 5000 hours
Bona Belt Lite Manual
27
EN