Kunzle & Tasin Bona Belt Lite Manuel D'utilisation page 22

Starting the Machine (Cont.)
If starting the machine is difficult in winter when temperatures are very low remove the abrasive belt and start the motor,
letting it idle for several minutes. Replace the belt and repeat the start up operations described.
12.
Observe the operation of
the abrasive belt. Follow the
procedures for 'Centering
The Abrasive Belt' on page
23. The belt must run inside
the tensioning unit (A) and
protrude by approximately
2mm from the rubber drum
(B).
15.
To stop the machine:
22
13.
Close the side guard (A).
Turn the knob
from "1" to "0"
A safety contactor is fitted to the machine. If the power fails when sanding the contactor is
activated automatically, stopping the machine from accidentally starting up when the power is
restored. To recommence sanding repeat the start-up operations described above.
14.
After lowering the lever (A),
commence sanding.
Bona Belt Lite Manual