Presetting Stations/Recalling A Preset Station From Preset Memories - PERFECTPRO Rock Pro 2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Search tuning FM (Seek station)
1. Press the Power On/Off button to turn radio on.
. Select FM band by pressing the Source button as described. Stand up the FM rubber antenna
properly to get best reception.
3. If this is the first time to search FM tuning, press and release the Tuning/Seek knob, and the radio
will seek forward and stop automatically when it finds a radio station with good signal. The radio
will seek forward for the next available station if pressing down the Tuning/Seek knob again.
4. For scanning station backward quickly, rotate the Tuning/Seek knob in an anticlockwise direction
first and then press and release it. Your radio will scan down the FM band from the currently
displayed frequency and will stop scanning when it finds a signal of sufficient strength.
To scan up in frequency, rotate the Tuning/Seek knob in a clockwise direction. The displayed
frequency will increase. Then press and release the Tuning/Seek knob to carry out an auto-tune.
Your radio will scan up the FM band from the currently displayed frequency and will stop scanning
when it finds a station of sufficient strength.
Presetting stations
You may store your preferred FM radio stations to the preset station memories (1 to 5). The
procedure for setting presets and using them to tune stations is described below.
1. Press the Power On/Off button to turn on the radio.
2. Press the Source button and tune to the required station as previously described.
3. Press and hold the required Preset button (1~5) until radio beeps once and the display shows
corresponding "Px" on the upper right corner.
4. Repeat this procedure for the remaining presets as you wish.
5. Stations stored in preset memories may be overwritten by following above procedures if required.
Recalling a preset station from preset memories
1. Press the Power On/Off button to turn on the radio.
. Press the Source button to select FM band.
3. Momentarily press the required Preset button (1~5) to cause your radio to tune to the station stored
in preset memory.
9
1
2
3
2
3

Publicité

Table des Matières
loading

Table des Matières