Search Tuning Fm; Presetting Stations / Recalling A Preset Station; Recalling A Preset Station - PERFECTPRO Rock Mate 2 Mode D'emploi

Search tuning FM

. Press the STANDBY button to turn radio on.
. Select FM band by pressing the SOURCE button as described. Stand up the FM rubber antenna
properly to get best reception.
. Press and release the Tuning/Seek knob, and the radio will seek forward and stop automatically
when it finds a radio station with good signal. The radio will seek forward for the next available
station if pressing down the Tuning control knob again.
Presetting stations
You may store your preferred FM radio stations to the preset station memories ( to 5). The
procedure for setting presets and using them to tune stations is described below.
. Press the STANDBY button to turn on the radio.
. Press the SOURCE button and tune to the required station as previously described.
. Press and hold the required Preset button (~5) until radio beeps and the display shows
corresponding "PX" on the upper right corner.
4. Repeat this procedure for the remaining presets as you wish.
5. Stations stored in preset memories may be overwritten by following above procedures if required.

Recalling a preset station

. Press the STANDBY button to turn on the radio.
. Press the SOURCE button to select FM band.
. Momentarily press the required Preset button (~5) to cause your radio to tune to the station
stored in preset memory.
1
2
3
2
3
GB
0