OPERATING THE RADIO
Manual Tuning
1.
Press the Power On/Off button to turn on the radio.
2.
Select the FM waveband by pressing the Source button.
3.
Rotate the Tuning Control knob too reach the required FM station.
The radio will change the frequency in steps of 50 kHz.
4.
Rotate the Volume Control knob to get the required sound level.
5.
Rotate the rubber antenna to get the best reception.
6.
To turn off the radio, press the Power On/Off button.
Seek Station
1.
Press the Power On/Off button to turn on the radio.
2.
Select the FM waveband by pressing the Source button.
3.
Press the Tuning Control knob to start the seek function.
4.
The radio will seek and stop automatically when it finds a station of sufficient signal
strength.
5.
To find other stations, press the Tuning Control knob again.
6.
To seek station in an opposite direction, rotate the Tuning Control knob clockwise
(to scan from low frequency to high frequency) or rotate anti-clockwise (to scan
from high frequency to low frequency), and press the Tuning Control knob.
7.
When the waveband end is reached, the radio will recommence tuning from the
opposite waveband end.
Memory Preset Stations
There are 10 memory preset in this radio.
1.
Press the Power On/Off button to turn on the radio.
2.
Select the FM waveband by pressing the Source button.
3.
Tune to the required station.
4.
Press and hold the required Preset button until the radio beeps and shows for
example "Preset 1 stored".
5.
Repeat step 3 and 4 for the remaining presets.
6.
Stations stored in the preset memories can be over-written by following the above
procedure.
Recall Stations from Preset Memories
1.
Press the Power On/Off button to turn on the radio.
2.
Select the FM waveband by pressing the Source button.
3.
Briefly press the required Preset button, the display will show the preset number
and station frequency.
7