GF JRGURED UP 3/4 Notice D'utilisation Et D'entretien page 63

- After mounting the locking sleeve, the
JRGURED UP cartridge or the by-pass plug
must be actuated once. To this end, turn
the Allen key (SW 10) clock-wise until the
JRGURED UP cartridge or by-pass plug are
flush with the locking sleeve. Then screw in
the JRGURED UP cartridge/by-pass plug
counter-clockwise until it stops to open the
shut-off unit.
Check whether the locking sleeve is
properly installed by unscrewing the
JRGURED UP cartridge/by-pass plug
until it stops. If there is no palpable
stop, remove and reinstall the locking
sleeve (see Section 1).
E
63