Selecting The Operating Mode; Boost Feature - vogelundnoot BLOWER 950W Notice D'utilisation

SELECTING THE OPERATING MODE

The button allows you to adapt the
operating schedule of your device to your
needs, depending on the season, whether
your home is occupied or not.
By pressing the button once or several
times, select the required mode.
Mode overview
In Automatic Mode, the device will auto-
matically change from Comfort mode to
Eco mode according to the established pro-
gramme.
Your device has been programmed and is executing Comfort and Eco mode
orders in line with the settings and time periods you have selected
and daily programme integrated" chapter page
2
If you do not want to use the programming feature.
The device equipped with occupancy detector is delivered by default with the
self-learning mode enabled.
Without occupancy detector, your device's default setting is non-stop Comfort
for 7 days a week.
In both cases, meaning you do not have to change any settings. Orders sent
by the pilot wire will only be applied
automatically receive and apply the programmed orders sent by your power
manager or your time switches (see "Information
about remote control by pilot wire" chapter page
3
On the version without occupancy detector, if the 7 day and daily programme is
not enabled or no orders are being sent by pilot wire, then your device's factory
settings mean that it will operate in non-stop Comfort mode, 7 days of the
week.
Non-stop Comfort mode. The device will
operate 24 hours a day to achieve the tem-
perature which has been set (e.g. 19°C). The
Comfort mode temperature level can be set
by the user (see page 6).
Eco, which means the Comfort Mode tem-
perature minus 3.5°C. This enables you
to lower the temperature without having
to reset the Comfort Mode temperature.
Select this mode for short-term absences
(between 2 and 24h )
and during the night.
This mode enables you to protect your home
against the eff ects of cold weather (frozen
pipes, etc.), by maintaining a minimum
temperature of 7°C in it at all times. Select
this mode when you will be away from your
home for a long time (more than 5 days).
Restoring factory settings
See page 21.
M16MI328 A01_01/18
Display
3
(see "7 day
6).
, thus your device will
10).

BOOST FEATURE

Important:
To activate Boost mode, press
be set at maximum for the time period you request. 60 minutes display
will ash by default.
Comment: if the heating indicator is switched on, the blower switches
on and heats the room in addition to the heat emitted by the device.
During the rst minute: the boost symbol and the heating indicator
appear and the duration count ash.
During the rst minute, you can modify the Boost duration from 0 to
the maximal authorised duration of the Boost, such as de ned during
the advanced settings (see page 14 for more details)
minutes (or more quickly by push superior to 2 seconds) by pressing
and . This modi cation will be saved and eff ective for the
next Boost.
After 1 minute, the Boost count begins and the time is running, minute
by minute.
After 1 minute, you can modify temporarily the duration: it
will be valid only for this active Boost and therefore non-recurring.
The blower stops, -- appears. The cursor moves above
order Comfort will be sent, the blower will be restarted until the count
end.
FILT
The blower continues to operate but does not heat up. Check if nothing is
put in front of the ventilation grid to not block the air ow. The lter could
be plug by dust, it must be cleaned
EN
, the desired temperature setting will
by intervals of 5
. When the
(see page 21).
4