Setting The Energy Type; Setting The Power; Internal Temperature Monitoring - vogelundnoot BLOWER 950W Notice D'utilisation

Increase the temperature measured by the ambient temperature sensor
by 2°C by pressing .
In our example the measured temperature by the sensor goes
from 21°C to 23°C.
To put the value of the correction to "0", do the following :
When the temperature measured by the sensor appears, press
for at least 3 seconds.
2
Important:

SETTING THE ENERGY TYPE

Our blower can be used to manage 2 types of energy:
- The electric energy provided by the home electric installation to control
an electric towel rails.
Or
- The hot water provided by the heat generator of the central heating
installation to control an hydraulic towel rails. In this case, the blower
will manage a motorized valve installed on the towel rails.
By default, the blower has been con gurated to control an electrical
towel rails.
ELEC
appears on the display. By pressing
change the energy type used by the towel rails.
M16MI328 A01_01/18
ELEC
HYdr
- To save and move automatically to the next setting press
To exit the Expert settings, press

SETTING THE POWER

1-
or
- To save and move automatically to the next setting press
3

INTERNAL TEMPERATURE MONITORING

An integrated overheating safety is present on our blower. It is acti-
vated when an internal temperature limit is reached: the blower and its
controller will stop immediately.
The maximum setting is preset to 65°C. You can adjust from 60°C to
90°C by intervals of 5°C.
Press
If you do not want to change it, press
tically to set the next setting.
or , you can
= electric energy
= hydraulic energy
or then save by pressing
EN
.
3 times.
.
.
: the device changes automa-
20