vogelundnoot BLOWER 950W Notice D'utilisation page 22

To clean the lter, proceed in the following order:
- Press the lter strip by the right or the left side then take it out from
its slot.
- Use a vacuum cleaner to eliminate the dust deposited on the lter.
If the lter is very dirty, wash it under the water tap with a damp
sponge. After washing the lter, let it dry.
FILT
- Once cleaned and dried, replace the lter in its slot by inserting it into
the runners.
M16MI328 A01_01/18
- Voltage when in use: 230V +/-10% 50Hz.
- Switch: approved cycle 10,000.
- Radio frequency: 2,4035 Ghz/ 2,4055 Ghz / 2,4075 Ghz.
- Maximum RF power transmitted: <1mW.
- Standby consumption: <1W.
Integrated tangencial blower and PTC cartridge:
- Built-in anti-overheating safety device (Overheating protection by bi-
metal TCO and thermal fuse).
- Relay.
Class II immersion heater:
- Maximum power of 1500W, resistive load.
- Relays and triac control device at zero voltage (triac protected by a
thermal fuse).
Power supply cable:
- Class II: 800 mm, 3 conductors.
Environment
- IP24 (blower horizontal oriented following installation).
We hereby declare under our sole responsibility that the products des-
cribed in these instructions comply with the provisions of Directives and
harmonized standards listed below:
- RED 2014/53/EU:
Article 3.1a (Safety): EN60335-1/EN60335-2-30/EN60335-2-
43/ EN62333
Article 3.1b (EMC): ETSI EN301489-1/ ETSI EN301489-3
Article 3.2 (RF): ETSI EN 300440
- ERP 2009/125/EC
- Regulation 2015/1188/EU
- ROHS 2011/65/EU : EN50581
and are manufactured using processes which are certi ed ISO 9001
V2008.
EN
22