Restoring Factory Settings; Maintenance And Cleaning Of The Dust Lter - vogelundnoot BLOWER 950W Notice D'utilisation

RESTORING FACTORY SETTINGS

If the PIN code protection is disabled, the user, installer and expert settings
are re-initialized:
From the internal temperature monitoring setting, press
appears on the display.
NO
ashes. Press or
yes
= Factory settings reset
NO
= Factory settings not reset
Press the key for 5 seconds. The device returns to its initial con -
guration and goes back automatically to the Auto mode.
The following factory values will be eff ective:
rest
.
YES
to select .
19°C
60 min.
Disabled
L3
-3,5°C
7°C
Enabled
7°C
30°C
60 min.
To exit the Expert settings, press
MAINTENANCE AND
CLEANING OF THE DUST
FILTER
Before any maintenance work, switch off the device by pressing the but-
ton (switch).
The device can be cleaned with a damp cloth; never use abrasives or
solvents.
The blower is equipped with a removable dust lter which retains
impurities from the air aspirated into the room.
When the lter is saturated, the dust accumulation may cause its stop.
FILT
In Boost mode, the writing
Before any action of lter removal, switch off the device by pressing the
button located under the blower.
EN
39°C
°C
Enabled
Enabled
Opti comfort
Disabled
0000
Elec
500W
90°C
3 times.
appears on the display.
M16MI328 A02_01/18
21