Handlebar Switches - Yamaha KODIAK YFM400AR Manuel Du Propriétaire

1. Light switch " / /OFF"
2. Engine stop switch "
3. Start switch " "
4. Horn switch " "
1. Contacteur d'éclairage "
2. Coupe-circuit du moteur "
3. Contacteur du démarreur "
4. Contacteur de l'avertisseur "
1. Interruptor de luces "
2. Interruptor de paro del motor "
3. Interruptor de arranque "
4. Interruptor de la bocina "
/ "
/ /OFF"
/ "
"
"
/ /OFF"
/ "
"
"

Handlebar switches

Light switch "
Set the switch to "
the taillight and the meter lighting.
Set the switch to "
the taillight and the meter lighting.
Set the switch to "OFF" to turn off all the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.
_
Engine stop switch "
Make sure that the engine stop switch is set to
" " before starting the engine. The engine stop
switch controls ignition and can be used at all
times to stop the engine, especially in an emer-
gency. The engine will not start or run when the
engine stop switch is set to "
4-11
/ /OFF"
" to turn on the low beams,
" to turn on the high beams,
/ "
".
EBU00053
EBU01251
EBU01205