Tips For Saving Energy - BORETTI BKI 178 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
BEFORE CALLING YOUR AFTER SALES SERVICE
34
Water flow noise: Normal flow noise of water flowing to the evaporation
container during defrosting. This noise can be heard during defrosting.
Air Blow Noise: Normal fan noise. This noise can be heard in fridges
during normal operation of the system due to the circulation of air.
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get
warmer during the operation of the compressor, this is normal.
If humidity builds up inside the fridge;
• Are all food packed properly? Are the containers dried before placing them
in the fridge?
• Is the fridge's door opened frequently? Humidity of the room gets in the fridge
when the door is opened. Humidity build up will be faster when you open the
door more frequently, especially if the humidity of the room is high.
If the door is not opened and closed properly;
• Do the food packages prevent closing of the door?
• Are the door compartments, shelves and drawers placed properly?
• Are door joints broken or torn?
• Is your fridge on a level surface?
Recommendations
• To stop the appliance completely, unplug from main socket (for cleaning and
when the door is left open)

Tips for saving energy

1. Install the appliance in a cool, well ventilated room , but not in direct sunlight
and not near a heat source (radiator, cooker.. etc). Otherwise use an insulating
plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. Cover drinks or other liquids when placing them in the appliance Otherwise
humidity increases in the appliance. Therefore, the working time gets longer.
Also covering drinks and other liquids helps to preserve smell and taste.
4. Try to avoid keeping the doors open for long periods or opening the doors too
frequently as warm air will enter the cabinet and cause the compressor to
switch on unnecessarily often.
5. Keep the covers of the different temperature compartments (crisper, chiller
...etc ) closed
6. Door gasket must be clean and pliable. Replace gaskets if worn.

Publicité

Table des Matières
loading

Table des Matières