Using For The First Time - BORETTI BKVDN-179 Mode D'emploi

USING FOR THE FIRST TIME

Connect the appliance to the power supply.
In models with electronics, a sound signal may be emitted, which means that the temperature alarm has
been activated: press the sound alarm off button. Where provided, position the antibacterial anti-odour
filter in the fan as demonstrated in the filter packaging.
Note: After turning the appliance on, you must wait for 4-5 hours for the correct storage temperature to
be reached for a normally filled appliance.
MAINTENANCE AND CLEANING
OF THE APPLICANCE
Clean the appliance occasionally with a cloth and a solution of warm water
and neutral cleaning agents specifically for cleaning the inside of the
refrigerator. Do not use abrasive cleaning agents. To ensure the constant
and correct flow of the defrosting water, regularly clean the inside of the
drain situated in the back wall of the refrigerator compartment near the
fruit and vegetable drawer using the utensil provided (see figure).
Before carrying out any maintenance or cleaning, take the plug out of the
socket or disconnect the appliance from the power supply.
REPLACING THE LIGHT BULB OR LED
(depending on the model)
Always disconnect the appliance from the power supply before replacing the light bulb. Then follow the
instructions based on the type of light bulb for your product.
Replace the light bulb with one with the same features, available from the Technical Assistance Service
and authorised sellers.
Light type 1)
To remove the light bulb, unscrew it in an anti-clockwise direction, as
shown in the figure. Wait 5 minutes before reconnecting the appliance.
- traditional light bulb (max 25W)
or
- LED light bulb (with the same features)
only available from the Technical Assistance Service
Light type 2)
If the product has LED lights, as demonstrated in the figures below, contact the Technical Assistance
Service if you need a replacement.
LEDs last longer than traditional light bulbs, improve internal visibility and are environmentally friendly.
LED- strip
n o a g D r
14
Light bulb
LED light bulb
et2