End Of Work; Cleaning The Machine - Dolmar TM-92.14 Manuel D'utilisation

HOW TO USE THE MACHINE
5.4.7 Unblocking the collector channel
Cutting very tall or wet grass, particularly at excessively high speed, can clog up the
collector channel. If this happens proceed as follows:
– stop moving forward, disengage the blades and stop the engine;
– remove the grass-catcher or stone-guard;
– remove the grass cuttings; you can reach them from the exit of the collector chan-
nel.
WARNING!
!
5.4.8 End of mowing
When you have finished mowing, disengage the blades, lower the engine speed and
ride the machine with the cutting deck raised as high as possible.

5.4.9 End of work

Stop the machine, move the throttle to «SLOW» and turn
off the engine by turning the key to «OFF».
When the engine has stopped, close the fuel stopcock (1)
➤
( if fitted).
WARNING!
!
throttle on «SLOW» for 20 seconds before stopping
the engine.
WARNING!
!
unattended!
IMPORTANT
position when the engine is not running.

5.4.10 Cleaning the machine

After use, clean the outside of the machine, empty the grass-catcher and shake it to
remove grass and other debris.
This job must only be performed with the engine turned off.
To avoid backfire, position the
Always take out the ignition key before leaving the machine
To keep the battery charged, do not leave the key in the «ON»
23
EN
1