Dolmar TM-92.14 Manuel D'utilisation page 102

20
EN
– if the engine is already warm, position the lever between «SLOW» and «FAST»;
– put in the ignition key and turn to «ON» to make electrical contact, then turn to
«START» to start the engine;
– release the key once the engine has started.
When the engine has started, move the throttle to «SLOW».
IMPORTANT
smoothly. Using it when the engine is already warm can foul the spark plugs and
cause the engine to run erratically.
NOTE
running the battery flat and flooding the engine. Turn the key to «OFF», wait for a few
seconds and then repeat the operation. If the malfunction persists, refer to the
engine manual and chapter «7» in this manual.
IMPORTANT
from starting if safety requirements have not been met ( ☛ 5.2).
In these cases, once the situation has been corrected, the key must first be turned
back to «OFF» before the engine can be restarted.
5.4.2 Starting and moving without mowing
WARNING!
!
It has to be used (as indicated by the highway code) in private areas closed to
traffic.
When moving the machine, the blades must be disengaged and the cutting deck
raised as high as possible (position «7»).
a ➤
Mechanical transmission:
«FAST», and the gear lever in 1st gear (☛ 4.22).
Keep the pedal pressed down and release the parking brake. Slowly release the
pedal to shift from "brake" to "clutch", thus operating the rear wheels (☛ 4.21).
WARNING!
!
engagement may cause the vehicle to tip over and the driver to lose control.
The choke must be closed as soon as the engine is running
If there are engine starting problems, do not insist as you can risk
Always bear in mind that the safety devices prevent the engine
This machine has not been approved for use on public roads.
The pedal has to be released gradually, as a sudden
Position the throttle between «SLOW» and
HOW TO USE THE MACHINE