Stabilizer And Fin Installation - Horizon Hobby HANGAR 9 P-47 Thunderbolt PNP Manuel D'utilisation

11. Mix 1/2 ounce (15mL) of 30-minute epoxy. Use an epoxy
brush to apply the epoxy to the exposed wood on the wing
root.
12. Apply epoxy to the exposed wood on the remaining wing
panel.
13. Slide the remaining wing panel on the wing tube. The wing
panels will fit together tightly and with no gaps. Use a paper
towel and isopropyl alcohol to remove any excess epoxy.
14. Use low-tack tape to hold the wing panels together until the
epoxy fully cures. Once cured, remove the tape from the wing.
Î It may be necessary to use a covering iron or heat gun to
carefully seal the covering back in position on the wing.
15. Connect the extension for the retracts to the retract leads
exiting the wing.
EN

STABILIZER AND FIN INSTALLATION

16. Remove the canopy hatch from the fuselage by sliding it
forward slightly. Lift the hatch at the rear and remove it from
the fuselage. Set it aside in a safe location.
17. Flex the elevator through its range of motion a few times to
break in the hinges.
18. Remove the lower fuselage cover from the fuselage. Set it
aside in a safe location.
19. Slide the stabilizer into the slot in the fuselage. The control
horn will face the bottom of the fuselage. Make sure the
stabilizer is fully forward and the slot in the stabilizer aligned
with the slot in the fuselage for the fin.
6