Din Rear-Mount; Fixing The Front Panel - Pioneer AVIC-N2 Manuel D'installation

Installation

DIN Rear-mount

Installation using the screw holes on the
side of the unit
• Fastening the unit to the factory
radio-mounting bracket.
Select a position where the screw holes
of the bracket and the screw holes of
this product become aligned (are fit-
ted), and tighten the screws at 2 places
on each side. Use any of screws (4 × 3
mm), binding screws (5 × 6 mm) or
flush surface screws (5 × 6 mm),
depending on the shape of the screw
holes in the bracket.
*1 Use screws (4 × 3 mm) only.
* 1
• When installing in a shallow space,
use the following screw holes. In
this case, stick conceal tape on parts
that protrude from the dashboard.
* 1
* 1
25
* 1
Conceal tape
Factory radio mounting
bracket

Fixing the front panel

If you do not operate the removing and
attaching the front panel function, use
the supplied fixing screws to fix the
front panel to this unit.
• Fix the front panel to the unit
using fixing screws after remov-
ing the front panel.
Fixing screw
Binding screw
(5 × 6mm)
Dashboard or
Console
Fixing screw