Pioneer AVIC-N2 Manuel D'installation page 13

Display unit
Power cord
Black, Orange/white, Red, Yellow
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the
lead whose voltage changes when the shift lever is
put in reverse. Unless connected, the sensor may
not detect your vehicle traveling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note: When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect it.
When you use a rear view camera, please make
sure to connect it. Otherwise you cannot switch to
rear view camera picture.
Do not use other than the supplied extension lead.
See Page 15.
Extension lead
(for reverse signal)
Note:
Cords for this product and those for other products may
be different colors even if they have the same function.
When connecting this product to another product, refer
to the supplied Installation manuals of both products
and connect cords that have the same function.
Yellow/black (GUIDE ON)
When combining this navigation unit with the other
Pioneer audio unit for the vehicle, if the vehicle
stereo has yellow/black leads, connect them to those
leads. In this way, when the guidance audio is output
and when you operate the system by voice, the vehi-
cle stereo is automatically muted to reduce the vehi-
cle stereo volume.
Fuse resistor
Check the position of your vehicle's
reversing lamp (the one that lights up
when the shift lever is in reverse [R])
and find the reversing lamp lead in the
trunk.
See Page 9.
Connection method
Clamp the reversing lamp
lead.
Clamp firmly with
needle-nosed pliers.
Reversing lamp lead
12