Recommended Cutting Equipment For Canada; Saw Chain Filing And File Gauges - Husqvarna 334T Manuel D'utilisation

Recommended cutting equipment for Canada

Following is a list of recommended cutting equipment for the Husqvarna chain saw models 334T and 338XPT. The
combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-
04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Guide bar and saw chain combinations, model 334T
Length, inch Pitch, inch
12 3/8
14 3/8
Guide bar and saw chain combinations, model 338XPT
Length, inch Pitch, inch
12 3/8
14 3/8
16 3/8
Saw chain filing and file gauges
38 – English
TECHNICAL DATA
Guide bar
Gauge, inch Max. nose radius
0,050 7 T
0,050 7 T
Guide bar
Gauge, inch Max. nose radius
0,050 7T
0,050 7T
10,050 7T
Saw chain
Type Drive link count
45
Husqvarna H37,
Husqvarna H36
52
Saw chain
Type Drive link count
45
Husqvarna H37,
52
Husqvarna H36
56