Recommended Cutting Equipment For Canada; Saw Chain Filing And File Gauges - Husqvarna 436 Li Manuel D'utilisation

Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna cordless chain saws model 436 Li and 536 LiXP.
This chain saw model equipped with either of the listed guide bar and saw chain combination(s), fulfills the requirements
according to UL 60745-1 and UL 60745-2-13.
Chain saw models Husqvarna 436 Li and 536 LiXP met the kickback performance requirements of ANSI B175.1-2012
when tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H38 is also classified
as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2012. We
recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna 436 Li and 536 LiXP.
Other chain saw models may not meet the kickback requirements when equipped with the listed bar and chain
combinations.

Recommended cutting equipment for Canada

Following is a list of recommended cutting equipment for Husqvarna cordelss chain saws models 436 Li and 536 LiXP.
The listed combination(s) of powerhead, guide bar and saw chain meet all requirements outlined in Canadian Standards
Assosiation Z62.1-11 (Chain Saws) and Z62.3-11 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated and listed as a Type C Low Kickback Saw chain according to
the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
The following cutting attachments are approved for the models Husqvarna 436 Li and 536 LiXP.
Length, inch Pitch, inch
10 3/8
12 3/8
14 3/8
Saw chain filing and file gauges
TECHNICAL DATA
Guide bar
Gauge, inch
0.043
0.043
0.043
Max. nose
Type
radius
7T
9T Husqvarna H38
9T
Saw chain
Drive link
count
40
45
52
English – 41