Machine-Specific Safety Warnings - Scheppach 5907303900 Traduction Des Instructions D'origine

1. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
89335 Ichenhausen
Germany
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non­compliance of the operating instructions,
Repairs by third parties, not by authorized service
•
technicians,
Installation and replacement of non-original spare
•
parts,
Application other than specified,
•
Unpacking
Open the packaging and remove the device care-
•
fully.
Remove the packaging material as well as the
•
packaging and transport bracing (if available).
Check that the delivery is complete.
•
• Check the device and accessory parts for trans-
port damage.
If possible, store the packaging until the warranty
•
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
2. Description
Moving jaw
1.
Fixed jaw
2.
Main body
3.
Lock/unlock switch
4.
5. Foot pedal
Foot pedal lock
6.
Front legs
7.
Front leg locks
8.
Rear leg
9.
Rear leg lock lever
10.
11. Bracket for front legs

3. Machine-specific safety warnings

m Please read the safety instructions! These in-
structions will make it easier for you to handle
the device and help prevent misunderstanding
and possible damage or injury.
Keep your work area tidy and well lit.
1.
Keep children and spectators away. Do not al-
2.
low people not involved to remain inside the work
area.
Make sure that all moveable parts can move free-
3.
ly.
Wear appropriate work clothes. Do not wear
4.
loose clothing that can become entangled in
moveable parts.
Use personal protective equipment such as pro-
5.
tective goggles, hearing protection and protective
gloves. Always use breathing protection when
working in a dusty environment.
Make sure that all fastening screws and buttons
6.
are screwed tight and that the legs are clicked
into place and secured before starting the device.
Make sure that the device is stable on a firm,
7.
even floor.
8. Ensure its balance. If large workpieces are cut
from one end, the remaining piece may be heavy
enough to topple the device. Always make sure
that the workpiece is secured.
Do not stand on the device.
9.
Only use the device for its intended purpose. Any
10.
use not listed in these operating instructions is
deemed improper use. The manufacturer does
not assume liability for damage or injuries caused
by improper use.
Use of accessories not mentioned in these oper-
11.
ating instructions can lead to injuries.
4. Installation
Installation
Place the device on the floor upside down, press
1.
the bracket (11) outwards to unlock the front legs
Fig. 2.
2. Fold the front legs (7) forwards until they click
into place. See Fig. 3+4
Loosen the rear leg lock (10) and push the rear
3.
leg (9) out of its resting position. Fold the leg
completely and push it down into its end lock po-
sition. Secure the rear leg locking lever. See Fig.
5+6
4. Fold the foot pedal (5) until it clicks into place.
See Fig. 7
Now position the device upright. Make sure that
5.
all legs are secured.
Folding up
Proceed in reverse order:
Make sure that the Lock/Unlock switch (4) is in
1.
the "Unlock" position. See Fig. 1.
GB 13