Adjusting Nylon Line - Shindaiwa T225S Manuel D'utilisation

1. Locking tool
1. Tap knob
2. Hit knob against the
ground surface lightly
2. Nylon line cutting head
3. Nylon line comes out
Before you start
Thread nylon line cutting head onto shaft (anticlockwise) until it is
tight.
Remove locking tool.
Nylon line cutting head
Type: G138
Thread: Left-hand thread M10×1.25 pitch

Adjusting nylon line

Make sure there is no bystander within 15 m radius and pay
enough attention to objects in the surroundings before starting
operation.
Do not rotate the nylon line cutting head at more than 10000 r/
min.
Do not hit the nylon line cutting head against hard foreign mat-
ters such as rocks, concrete, tree stub and bottle etc.
When releasing nylon line from spool hit tap knob of spool
against the ground surface lightly at rotation speed lower than
4500 r/min.
Cut off knife on the shield adjusts cutting swath automatically
by cutting nylon lines evenly when attachment starts rotating.
When operating with less than maximum cutting swath, cut
two nylon lines in equal lengths.
Replacing nylon line
Shut down trimmer engine without fail and make sure ny-
lon line cutting head has stopped rotating before starting
replacement procedure.
19
DANGER