U-handle version
1. Bolt M5×25
1. Wire fixing clips
2. Shaft tube
2. Handle bar support
3. Throttle wire
Before you start
Make sure each outer periphery of pawls of housing
spreads almost fully up to the outer periphery of respec-
tive window of cover.
If they are loosely fitted and the cutting head is turned,
cover or inside components can fly off which is danger-
ous.
U-handle assembly
ILoosen handle bar support bolts.
Locate handle bar in a comfortable operating position and tighten
4 bolts (M5×25).
Install the handle so that it does not hide any of the
safety decals.
To eliminate loosening of throttle wire fix it to shaft tube (2 places)
and to right hand U-handle (1 place) with wire fixing clips.
21
DANGER
CAUTION