Shindaiwa T225S Manuel D'utilisation page 22

Before you start
1. Housing
2. Cover
1.Intermediate separator
2.Bent portion
3.Notch Nylon line
3. Spool
4.Winding direction for the
line
5.If wound unfirmly, the
line loosens.
6.Wind firmly into respec-
tive groove.
1. Press "retaining pawls" (at two places) inward and remove
cover.
It is easier to remove one after another.
2. Remove spool.
3. When nylon line on the spool is almost exhausted, remove
remaining line from spool and wind "new line" according to
the procedures (4) and beyond.
When the line on the spool is "melted and stuck" remove the
entire line while peeling off the "melted and stuck" portion
and wind the "removed line" anew according to procedures
(4) and beyond.
4. Bend the line at the point 10 cm away from the middle of
whole length and hook the bent portion into the "notch" of the
intermediate separator.
5. Wind the line firmly into groove of the spool following "wind-
ing direction for the line L".
6. When the line is wound to the end hook both line ends into
respective notch of spool for retaining tentatively the line
while leaving line ends approximately 10 cm beyond notch.
7. Align notches of spool for the line with grooves of eyelets
and fit spool into cover.
8. Pull out the line from cover.
(A) Remove the line from "respective notch of spool", and (B)
pass it through "groove of respective eyelet".
9. Fit cover and housing together.
(C) Align "eyelets" of cover with "recesses" of housing, and
(D) press pawls of housing into respective window of cover
until the pawls are firmly fitted into the windows.
20