Angle Transmission; Checking The Blade - Shindaiwa T225S Manuel D'utilisation

Maintenance and care
Check spark plug
a: 0.6 - 0.7 mm
Lubricating drive shaft
1. Drive shaft

Angle transmission

1. Angle transmission

Checking the blade

2. Plug (Bolt)
Check plug gap. Correct gap is 0.6 mm to 0.7 mm.
Inspect electrode for wear.
Inspect insulator for oil or other deposits.
Replace plug if needed and tighten to 15 N·m - 17 N·m (150
kgf·cm to 170 kgf·cm).
Inspect the drive shaft (flexible shaft) every 50 hours of use and
replenish grease if it is insufficient.
NOTE
Use good quality lithium multi grease.
Remove plug from angle transmission.
Add grease, if necessary, using low pressure pump.
NOTE
Use good quality lithium multi grease.
Do not overfill housing.
Reinstall plug.
Use only blade designated for this model by the manufacturer.
When a crack is noticed on the blade, do not use it but replace
with a new one.
Ensure that the blade is correctly fitted in accordance with the
instructions.
38