LGB Rü. KB IVK 99594 Instructions De Service page 20

64 = lighting button 9 (ON only when loco is reversing)
65 = button 1 (ON only when loco is reversing)
128 = lighting button 9 (ON only when loco is moving forward)
129 = button 1 (ON only when loco is moving forward)
(Depends on loco model, do not change, as functions
can be affected or destroyed)
CV52 Command key for front lighting terminal (see CV51)
CV53 Command key for rear lighting terminal (see CV51)
CV54 LGB configuration [2]
Bit configuration
Bit 1: hand-off function, 0 = off, 1 = on [0]
Bit 2: MTS Back-EMF, 0 = off, 2 = on [2]
Bit 3: analog Back-EMF, 0 = off, 4 = on [0]
Bit 4: no function
Bit 5: 0 = F1 constant, 16 = F1 flashing [0]
Bit 6: 0 = F2 constant, 32 = F2 flashing [0]
Bit 7: 0 = two chuffs/revolution,
64 = four chuffs [0]
Bit 8: automatic brake sounds, 0 = on, 128 = off [0]
To program, add the values for the individual bits and
program the resulting function value.
The values for Bits 5-8 vary between locos. The values for
your loco can be read using the 55045 MTS PC Decoder
Programming Module.
Hand-off function ON: When operating with 55015, you
can adjust direction and speed for two seconds after
selecting a loco in motion without causing the loco to stop.
CV55 Recover factory-set values of the CV configura-tion:
6-55->
5-55->
CV56 Voltage for function terminal F2
(depends on loco model, do not change, as functions can
be affected or destroyed)
CV57 Command key for function terminal F2 (see CV51)
CV58 Pause time (analog operation) (0.5 seconds x function
value) (0-255) [0]
When the polarity of the analog track voltage is reversed,
the loco waits for the programmed time period, then
accelerates in the new direction.
CV60 Back-EMF: max. adjustment factor
Specifies the maximum increase or decrease of voltage
applied during each time interval (programmed in CV61)
1 = small adjustment steps,
255 = large adjustment steps
The factory-set values are optimized for LGB motors.
CV61 Back-EMF: adjustment frequency
Specifies how often per second the motor voltage is
adjusted - accordingly, the loco will react to curves and
grades immediately or with a short delay
0 = immediate adjustment, 255 = maximum delay
22
[128]
[64]
[2]
(1-32) [5]
[15]
(0-255) [0]
(1-255) [4]
(0-255) [16]