Publicité
Les langues disponibles
Les langues disponibles
Programming
Numerous functions of the onboard
decoders can be configured, e.g.
- Acceleration
- braking response
- direction of travel
- and many more.
4
The decoder can either be configured
using the 55045 MTS- PC Pro gram -
ming Module or the 55015 MTS Uni -
versal Remote Control Unit.
SERVICE
Do-it-yourself service levels
- Beginner
- Intermediate
- Advanced
ATTENTION! Improper service will
void your warranty.
Note:
For quality service, contact your au -
thorized retailer or an LGB factory
ser vice station (see Authorized
Service).
Lubrication
- The axle bearings and the side rod
bearings should be lubricated
occasionally with a small amount
of LGB Maintenance Oil.
Cleaning
- This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water.
ATTENTION! Do not immerse this
model in the detergent.
ATTENTION! If the model is equipped
with a loudspeaker, it must not be ex -
posed to water directly.
Replacing the light bulbs
- Carefully pry the lens away from
the lantern.
- Using tweezers, remove the bulb.
- Plug in new bulb.
- Reassemble.
Interior lighting
- Using tweezers, remove the bulb.
- Plug in new bulb.
Replacing the steam generator
- Pull the safety cover out of the
smoke stack (Fig. 5).
- Use pliers or tweezers to pull the
old steam generator out of the
stack.
4
- Cut the wires.
- Connect the wires to the new gen-
erator. Twist the stripped wire ends
and insulate them (Fig. 6).
- Push the new generator into the
stack.
- Reassemble.
Replacing the traction tire
- Loosen the screw in front of the
rear gearbox.
- Remove the screw at the rear cou-
pling.
- Remove the two hex head screws
from the rear drive wheels and lift
off the driving rods.
- Pull off the rear gearbox from the
loco.
- Use a small, straight screwdriver
to replace the old traction tire:
- Pry the old traction tire out of the
wheel groove.
- Gently push the new traction tire
over the wheel and into the groove
of the traction wheel.
- Make sure that the traction tire is
seated properly in the wheel
groove.
- Reassemble.
:
:
2
19
Publicité
