LGB Rü. KB IVK 99594 Instructions De Service page 19

The following registers can be configured:
Register Function
CV1 Loco address
With LGB Multi-Train System
CV2 Starting voltage
Voltage for speed setting 1 - if loco only starts at a
higher speed setting, increase value.
CV3 Acceleration
Acceleration (1 = fast, 255 = slow)
CV4 Braking
1 = fast, 255 = slow
CV5 Maximum track voltage
Voltage for highest speed step - if a lower top speed is
desired, decrease value.
CV5 Function value for CV to be programmed after input of
CV6 (when programming with older 55015)
CV6 CV to be programmed
(when programming with older 55015)
CV29 NMRA configuration
Bit configuration
Bit 1: direction of travel, 0 = normal, 1 = reversed [0]
Bit 2: speed steps, 0 = 14 (LGB), 2 = 28 [0]
Bit 3: analog operation, 0 = not possible, 4 = possible [4]
Bit 4: not assigned [0]
Bit 5: speed steps table, 0 = factory-programmed,
16 = user-programmed [0]
Bit 6: address area, 0 = 0-127 (LGB), 32 = 128-10039 [0]
To program, add the values for the individual bits and
program the resulting function value.
Note: To program a loco to reversed direction of travel
(e.g. F7 A-B-A combination), program function value 5.
Attention! Loco addresses 128-10039 and 28 speed
steps cannot be used with LGB MTS.
CV49 Voltage for function terminal F1
(depends on loco model, do not change, as functions can
be affected or destroyed)
CV50 Voltage for lighting terminals (see CV49)
CV51 Command key for function terminal F1
0 = lighting button 9
1 = button 1 (buttons 2-8 not assigned)
9 = button 1 (buttons 2-8 also assigned)
10 = button 2
11 = button 3
12 = button 4
13 = button 5
14 = button 6
15 = button 7
16 = button 8
Available Factory
values setting
(00-22) [3]
(0-255) [2]
(1-255) [3]
(1-255) [3]
(1-255) [255]
[4]
(1-32) [32]
(1-32) [5]
[13]
21