Safety Precautions; Test Symbols; Licences / Certificates; Register Your Product - Stiebel Eltron TEMPRA 12 TREND Notice D'utilisation Et Installation

OPERATION

REGISTER YOUR PRODUCT

2.2

Safety Precautions

DANGER: Injury
!
Please read and follow these instructions. Failure to
follow these instructions could result in serious per-
sonal injury or death.
DAMAGE TO THE APPLIANCE AND THE ENVIRONMENT:
!
The appliance must be installed by a licensed electrician
and plumber. The installation must comply with all na-
tional, state and local plumbing and electric codes.
Service of the appliance must be performed by qualified
service technicians.
DANGER: Electrocution
Before proceeding with any installation, adjustment,
alteration, or service of this appliance, all circuit
breakers and disconnect switches servicing the appli-
ance must be turned off. Never remove the appliance's
cover unless the electricity servicing the appliance is
turned off. Failure to do so could result in personal
injury or death.
The appliance must be properly grounded. Failure to
electrically ground the product could result in serious
personal injury or death.
DANGER: Burns
Water temperatures over 125°F (52°C) can cause
severe burns instantly or death from scalding. A hot
water scalding potential exists if the thermostat on
the appliance is set too high. Households with small
children, disabled or elderly persons may require that
the thermostat be set at 113°F (45°C) or lower to
prevent possible injury from hot water.
WARNING: Injury
!
Where children or persons with limited physical, sen-
sory or mental capabilities are to be allowed to con-
trol this appliance, ensure that this will only happen
under supervision or after appropriate instructions by
a person responsible for their safety. Children should
be supervised to ensure that they never play with the
appliance.
2.3

Test symbols

See the type label on the appliance.
2.4 Licences / certificates
- UL (U.S.A) Std. 499
- CSA (Canada) Std.
C22.2 No.88
- NSF/ANSI 372
WWW.STIEBEL-ELTRON-USA.COM
3. Register your product
You must register this product within 90 days of pur-
chase on our web site in order to activate the standard
warranty. Go to our web site at
www.stiebel-eltron-usa.com and click on register
your product.
Before beginning the registration process, we suggest that
you gather the necessary information which will be as
follows:
Type, Example: Tempra 24 Plus (from the label that is on the
unit)
Number listed after "Nr."
Place of Purchase
Purchase Date
First & Last Name
Email address
Physical Address
Phone Number
Installation Date
IF YOU HAVE ANY QUESTIONS CONCERNING THE REGISTRA-
TION PROCESS OR WARRANTY, PLEASE CONTACT STIEBEL EL-
TRON USA DIRECTLY AT (800)-582-8423.
4.

General

The Tempra Trend and Tempra Plus units are designed to supply
hot water for a house, apartment or certain commercial applica-
tions. Unlike a conventional storage type water heater, the Tempra
tankless water heater does not store hot water. Instead, water is
heated instantaneously as it flows through the unit. The Tempra
offers greater energy efficiency than storage type water heaters
due to the absence of stand-by losses and reduced hot water
pipe runs.
The input of heat into the water is controlled electronically. The
Tempra will deliver any water temperature between 68°F (20°C)
and 140°F (60°C). Set the desired temperature using the knob on
the front cover. The Tempra Trend and Tempra Plus temperature
adjustment knob can be set to: OFF, 68-140°F (20-60°C). The max-
imum temperature is electronically limited to 140°F (60°C).
For reasons of appliance efficiency and durability (scaling), the
optimum temperature setting lies between 86 °F (30 °C) and
120 °F (50 °C).
The Tempra has a built-in display that allows for user customiza-
tion and information feedback.
TEMPRA TREND & TEMPRA PLUS | 3