Channel Configuration - Cristec JBNUM II-CPS3 Manuel D'utilisation

CHANNEL CONFIGURATION

To access to the general setup menu of the Battery
1
Monitor, when you are viewing the status of yours
power sources and batteries, press the button
_MENU_. The setup menu appears on the screen.
Then select the channel you want configure and
2
press _ OK _.
Information on the configuration settings of a channel :
Parameters
Battery Capacity
(Only Battery Installation Type)
Ah Counter
(Only Source Installation Type)
Battery Initialization
(Only Battery Installation Type)
Reset Ah Counter
(Only Source Installation Type)
High Voltage Alarm
Low Voltage Alarm
Low Capacity Alarm
(Only Battery Installation Type)
KitShunt Reference
Choice of settings
• 5 to 4000 Ah
• ON
• OFF
-
-
• OFF
• 0,1 to 60 V
• OFF
• 0,1 to 60 V
• OFF
• 1 to 100 %
• 250 A
• 500 A
Battery Monitor JBNUM II - CPS3
Principle
Battery capacity in amp-hours (Ah). It is the
ability to a discharge in 20 H and at 20 °C.
Default : 100 Ah
Stepsize : 1 Ah
When it is a source type installation, it is possible to
activate a ampere-hours counter supplied by the source
being monitored.
The initialization can set the state of full charge the
battery (100%).
See « Battery Initialisation »
When it is a source type installation, it is possible to
reset the ampere-hours counter.
When the battery voltage rises above this value,
an alarm is actived.
Default : 16 V
Stepsize : 0,1 V
When the battery voltage falls below this value,
an alarm is actived.
Default : 10,5 V
Stepsize : 0,1 V
When the battery capacity falls below this value,
an alarm is actived.
Default : 50 %
Stepsize : 1 %
This is the value of the KitShunt installed.
(KitShunt 500A optional)
Default : 250 A
50