First Powering - Cristec JBNUM II-CPS3 Manuel D'utilisation

FIRST POWERING

Once the Battery Monitor is connected and powered, the system automatically starts.
Channel 1 is displayed.
If other channels are connected, it is necessary to activate them in order to view them.
Please follow the below procedure:
_MENU_
General setting
- To set the parameters for each channel (capacity, alarms,...), follow the procedure
«
CHANNEL CONFIGURATION
Battery Monitor JBNUM II - CPS3
Installation Type
» page 50.
46
Not connected
Battery
Solar Panel
Wind Generator
Alternator
Other energy source
OK