Cristec JBNUM II-CPS3 Manuel D'utilisation page 32

INTRODUCTION
The battery monitor JBNUM II - CPS3 was designed to check the state of charge,the
voltage, the current and the capacity of your batteries.
This system is compliant with all Lead batteries (Opened, Classic Sealed, Gel, AGM,
Tin Calcium, and Spiral, etc.), Nickel Cadmium (Ni-Cd) and Lithium, with a capacity
ranging from 5 to 4000 Ah, 12V or 24V or 48V or even mixed (look at the
recommended wiring diagram page 39, 40, 41, 56 and 57).
This monitor has an electrical contact which allows genset remote that can be set frow
a low capacity and/or a low voltage.
We advise you to read the instructions below to have a better understanding of the
opportunities offered by your battery monitor. We hope that our product will give you
entire satisfaction.
BATTERY CHECKING
It is therefore important to monitor the status of your battery by a system, such as
the Battery Monitor, to act in time and thus prolong the life of your batteries.
The battery technology is responsive to its type of use. A wrong use
can have an irreversible degradation of your battery. There are some
precautions to ensure maximum service life for your batteries:
- Never make deep discharge,
- Never over-charge,
- Avoid too fast discharge,
- Avoid too high ambient temperature.
Battery Monitor JBNUM II - CPS3
32