Cristec JBNUM II-CPS3 Manuel D'utilisation page 37

Battery Monitor JBNUM II - CPS3
► Battery Monitor Installation
- Proceed a cutting-off in the on-board panel where the unit will be installed
according to the here-after drawing. (Panel cutting in page 58)
100 110
Ø 4
100
110
- Install the Battery Monitor inside the on-board panel cutting-off.
- Fix the on-board panel cutting-off through 4 off M3 screws cylindrical slit top + 4
off M3 nuts + 4 off M3 plain washers. The screw's length should be chosen
depending on the thickness of the main on-board panel where the monitoring system
will be fitted in.
37