Delivery Count - Nuova Simonelli AURELIA II Manuel D'instructions

DELIVERY COUNT

The display will read:
DELIVERY COUNT
By pressing the key the display will
read:
SELECTION TOTAL
SELECT
All the delivery keys will start to flash on and
off. By pressing one of the delivery keys the
amount of the deliveries made will be visual-
ised.
Hold down the key for 3 seconds to
reset.
NOTE: The continuous coffee equals one deliv-
ery.
Press the key and the display will
read:
MACHINE TOTAL
DELIVE. XXXX
This indicates the total amount of deliveries
made.
Hold down the key for 3 seconds to
reset.
By pressing the key the display will
read:
CLEANING COUNTER
To access the automatic cleaning counter
press .
The long coffee keys
will begin to flash; when the group key is
pressed, the display will show the number of
wash cycles carried out. Hold down the
key for 3 seconds to reset.
64
ACTIVE UNITS (T3 version only)
It is possible to set both the units actually
present and those to be enabled when the
control unit is switched on.
To set the number of active units when the
machine is switched on and to change the
active units, proceed as follows:
Switch on the function by pressing the
key.
It is possible to activate/deactivate individual
units by pressing the
Press
the next unit. When the last unit is confirmed,
the function returns to the main menu.
Pressing the
main menu and any changes made will not
be saved.
NOTE: To make a change effective, it is neces-
sary to switch the machine off and then
on again, using the main switch located
in the bottom right.
NOTE: From the machine ready state, it is pos-
sible to activate/deactivate the deacti-
vated/activated units by pressing the
in question. This temporary change is
active until the machine is switched off
and then on again from the main switch.
NOTE: If the electronic control unit is replaced,
when the "ACTIVE UNITS" are shown
on the display, it is necessary to press
the
and second group to make sure that in
on the machine
the "ACTIVE GROUPS X" on the dis-
play, X actually corresponds to the
number of units installed on the
machine.
keys.
to confirm and to pass on to
key returns to the
key and the button for the unit
long coffee key for the first
It is possible to change the value with
the keys.
For machines with 2 units, the value
should be X=2, for machines with 3 units,
the value should be X=3, for machines
with 4 units, the value should be X=4.
ON/OFF PROGRAM.
The display reads:
ON-OFF PROGRAM
By pressing the display will reads:
MONDAY
ON 07:30 OFF 23.30
where the ON and OFF values indicate
when the machine will turn on and off.
Press to change the day
forward and backward.
Press to vary the programmed
starting up time (the message ON 07:30 will
start to flash on and off).
Use the keys to vary the
starting up time.
Press to confirm and to go on to the
programmed switching off time (the mes-
sage OFF 23.30 will start to flash on and
off).
Use the keys to vary the
switching off time.
Confirm by pressing
To de-activate the on/off function on weekly
day-off, press .
The display will read:
DAY OFF
(to reinstate, press )
After the word SUNDAY, by pressing
again, a beep will signal that you
have come to the following page.
.