4.3 GROUP TEMP
(Pouring group temperature)
It is possible to programme the temperature of the
pouring group.
Pressing ENTER
the sub menu; the
to increase/reduce the temperature of the pouring
group ( T permitted ± 3°C).
Press ENTER
to confirm settings.
5.
SAVE DATA
Pressing ENTER
set during the programming stage in the machine's
memory.
Pressing RESET
programming mode without saving.
50
it is possible to enter
keys are used
is possible to store all data
it is possible to quit the
8.
CLEANING AND
MAINTENANCE
NEVER use water jets to clean the machine.
During maintenance/repairs, the parts used must be
able to guarantee compliance with the safety and
hygiene requirements envisaged for the device.
Original replacement parts can offer this guarantee.
After repairs to/replacement of a part that comes into
contact with foods or water, it is necessary to carry out
a washing procedure or to follow the steps indicated
by the manufacturer.
8.1
CLEANING THE
OUTSIDE OF THE
MACHINE
Before carrying out any cleaning operations, set the
machine to the "O" energy level, (machine switched
off and plug removed from the mains).
Never use solvents, chlorine-based products,
abrasives.
Cleaning the work area: slide out the work top and
remove the drip tray; clean all with hot water and
detergent.
Cleaning the external surfaces: To clean the pan-
els, use a soft, damp cloth.
8.2
CLEANING THE
DELIVERY UNIT AND
THE MILK FOAMER
NOTE: Follow the instructions on the label applied on
the inside of the front door.
EN
WARNING
Fig. 25
WARNING