Nuova Simonelli AURELIA II Manuel D'instructions page 69

has an associated value, the starting up time
of the cup-warmer is given by adding up the
values of the first unit's lit-up keys.
The same counting method is used for the
cup-warmer switching off time with the keys
of the second unit.
Keys 1° GROUP
(time ON)
2 minutes
4 minutes
8 minutes
16 minutes
If at least one of the two times is null, the cup
warmer will operate normally.
LEVELLING PUMP ACTIVATION
Access the programming of the first group
according to the relative procedure.
Press the second unit continuous
(the key will light up).
Press the second unit 1 small coffee
key.
NOTE: If the I small coffee
the pump will start up during the level.
If the 1 small coffee
up, the pump will not start up during the
level.
2° GROUP
(time OFF) Press the second unit continuous
key.
In this way the selected pump setting is
5 minutes
stored.
To exit the programming, press the first
10 minutes unit continuous
NOTE: The settings will be saved even when
exiting the first unit programming directly.
20 minutes
ADJUSTING KEYBOARD LIGHTING
40 minutes
INTENSITY
Access the programming of the first group
according to the relative procedure.
Press the second unit continuous
delivery key.
The second unit 2 long coffees
key will flash on and off.
Press the key more than once to vary the
light intensity.
NOTE: You can set a maximum of five different
degrees of light intensity.
To store the set light intensity values in the
memory, press the second unit continuous
key
delivery key.
To exit the programming, press the first unit
continuous delivery key
NOTE: The settings will be saved even when
exiting the first unit programming directly.
STEAM NOZZLE WITH TEMPERATURE
key is lit up,
PROBE (OPTIONAL)
Make sure the temperature probe is con-
key is not lit
nected to the control unit.
The temperature value can be planned by
sampling or manually depending by the
types of memorization planned in the param-
eter setting section and value goes from a
minimum of 50°C to a maximum of 95°C.
By pressing the
group is possible to chose if you wont set the
key. steam temperature value manually or by
sampling.
When you enter in this part of the menu, the
key of the second group is switched on.
By pressing the key
group, it is possible to change the way in
which settings are stored to memory.
Pressing the
change the memory storage mode.
del
Press the continuous delivery key
the 2nd unit to memorise the temperature
value input mode.
delivery
Sampling:
After entering in the program of the first
group, put a jag with milk under the steam
wand and press the
of steam will start.
By pressing again the
reached the maximum temperature, the con-
trol board memorizes the temperature
reached. (If the temperature of the milk
reaches the maximum level, steam delivery
.
is stopped and the maximum value is set in
the control unit).
key of the second
of the second
two short coffees key will
for
key, the delivery
key, or if it is
71