Aurelia V - S; Aurelia Digit - V - Swith Led System (Optional) - Nuova Simonelli AURELIA II Manuel D'instructions

selection keys are activated.
POWER OFF: press the
seconds; the machine will turn
off and the display will read:
OFF
Automatic On/Off PROGRAMMED
NOTE: make sure that the general switch is
always on the position "I".
The state of the machine will be shown
by the signal:
The machine will SWITCH ON at the first
programmed switch-on time (see the sec-
tion entitled PROGRAMMING at the para-
graph PROGRAMMING ON - OFF).
The control unit will perform
an auto diagnosis of all func-
tions and all of the selection
keys will light up. Once the
diagnosis is complete, the dis-
play will read as follows:
HEATING
with the date and time. Once
the temperature of 110°C has
been the word "Heating" will
disappear to be replaced by:
MACHINE READY
NOTE: once the auto diagnosis has been com-
pleted all the keys are activated.
WARNING
In case the auto diagnosis indicates error or
malfunction, call the assistance centre; the
operator MUST NOT intervene.
The machine will SWITCH OFF at the first
time set for stopping the coffee maker (see
key for 2
chapter on PROGRAMMING and paragraph
on PROGRAMMING ON – OFF).
NOTE: the machine can be switched on or off
manually as indicated in the previous
paragraph.
6.2.2

AURELIA V - S

SWITCH ON: plug the machine in and posi-
tion the main switch on "I".The
state of the machine will be
shown by the signal:
In case the auto diagnosis indicates error or
malfunction, call the assistance centre; the
operator MUST NOT intervene.
SWITCH OFF:
Fig. 21
WARNING
press the main switch into
the "O" position to switch the
machine and the signal off.
6.2.3 AURELIA DIGIT - V - S
WITH LED SYSTEM
(OPTIONAL)
SWITCH ON: plug the machine into the
power socket and press the
switch "A" so it is in position "I";
the machine will switch on.
Pressing the switches "B" and
"C" so that they are in position
"I" will switch on the LEDs
even when the machine is
switched off.
A B
WARNING
In case the auto diagnosis indicates error or
malfunction, call the assistance centre; the
operator MUST NOT intervene.
C
Fig. 22
57