Nuova Simonelli AURELIA II Manuel D'instructions page 67

To remove the MAINTENANCE message,
move the date forward or increase the num-
ber of coffees.
WASHING ALARM
This is used to set the timer (hour and minutes)
for the unit washing alarm.
The function can be accessed by pressing the
key.
The keys can be used to
select the ACTIVE and NOT ACTIVE options.
Using the key to select NOT ACTIVE
will return to the main menu, while selecting
ACTIVE means it is necessary to use the
and
hour and minutes after which the alarm will be
displayed. After the minutes have been set, the
function returns to the main menu.
Pressing the key returns to the main
menu and any changes made are not saved.
SELECTING THE DESIRED
LANGUAGE
The display will read:
LANGUAGE
Press the key to visualise the lan-
guage already set. Choose the desired lan-
guage by using the
Press to confirm and pass to the
next step.
Press to return to the previous
page without confirming.
TEMPERATURE UNITY MEASURE
SELECTION
The display reads:
Premendo il tasto
keys to set the
Press
ures unit setted.
Press
next step.
Press
without confirming.
KEYBOARD LIGHTING
ADJUSTMENT
The display reads:
keys.
By pressing
read:
KEYS
DISPLAY
TEMPERATURE
, il display visualizza:
TEMPERATURE
FAHRENEIT
Or
TEMPERATURE
CELSIUS
to modify the meas-
to confirm and pass to the
to return to the previous page
LIGHT ADJUSTMENT
key, the display will
X
Y
With the "keys X" light blinking, select the
value of desired brightness choosing from a
minimum value of 1 to a maximum of 6 by
using the keys.
Confirm by pressing
The temperature "display Y" value blinks
and with keys it is possible
to set the display lighting "display Y" from a
minimum value of 1 to a maximum of 3.
Press to confirm and pass to the
next step.
Press to return to the previous page
without confirming.
SETTING THE TEMPERATURE POINT:
+ press ENTER + UP to go
directly to the Setting Point menu (this will be
bars or °C/°F depend on the status view you
were).
press UP or DOWN to move
up and down the working Point.
Press to confirm and pass to the next
step.
MONITORING UNIT (°C/°F – BAR)
The display can also show you the pressure or
temperature status of the boiler; to pass from
one to the other, press the
display.
In the case of pressure, the reading will be
shown in bar, while for temperature, it will be in
degrees Celsius (°C) or Fahrenheit (°F). The
display setting for the temperature can be cho-
sen from the setpoint setting page. In fact, when
choosing the temperature mode, the setpoint will
be shown in degrees Celsius or Fahrenheit
according to the chosen measurement.
.
key on the
69