Table des Matières
Publicité
ANNEXE 3 INSTALLATION DES CAPTEURS DE TEMPÉRATURE
Maintenance & Replacement
Aquatic growth can accumulate rapidly on the sensor's surface
reducing its performance within weeks. Clean the surface with a
®
Scotch-Brite
scour pad and mild household detergent taking
care to avoid making scratches. If the fouling is severe, lightly wet
sand with fine grade wet/dry paper.
Anti-fouling Paint
Surfaces exposed to salt water must be coated with anti-fouling
paint. Use water-based anti-fouling paint only. Never use ketone-
based paint since ketones can attack many plastics possibly
damaging the sensor. Reapply anti-fouling paint every 6 months
or at the beginning of each boating season.
Replacement Sensor & Parts
The information needed to order a replacement sensor is printed
on the cable tag. Do not remove this tag. When ordering, specify
the part number and date. For convenient reference, record this
information at the top of page one.
Lost, broken, or worn parts should be replaced immediately.
Hull nut
Obtain parts from your instrument manufacturer or marine dealer.
Gemeco
(
U
S
) A
Airmar EMEA
(Europe, Middle East, Africa) Fax:
AP-8
02-031-3
Tel:
803-693-0777
F
a
: x
8
0
3
6 -
9
3
0 -
4
7
7
email: sales@gemeco.com
Tel:
+33.(0)2.23.52.06.48
+33.(0)2.23.52.06.49
email: sales@airmar-emea.com
3
Publicité
Table des Matières
