Rice Cooker - Tiger JKT-D10U Mode D'emploi

11
Cleaning and Maintenance
„ Installing the steam cap gaskets
Set the gaskets securely onto the steam cap as
shown in the figure below. If the gaskets are not
set securely, they can become loose and this may
result in problems due to steam leaking out, etc.
Note
● Do not remove the O-ring. Securely reattach the
gasket or O-ring if it comes off.
If it is difficult to attach, slightly moisten the O-ring
with water to make it easier to attach.
Removing odors
The following procedures should be performed if odors become an issue:
Caution
● Prior to cleaning after cooking, allow the rice cooker to cool. Otherwise, burns and injuries may be caused
by hot surfaces.
„ Rice cooker
1
Fill the inner pot to 70 to 80%,
select the "Plain/White" menu
and press the [Start] key.
Once the cooking cycle is
complete and the Keep Warm
lamp lights up, press the
[Cancel] key.
Note
● If odors become an issue, add citric acid
(approx. 0.71 oz) to the water for more effective
deodorizing.
If there are issues with removing odors, contact
an authorized service representative.
34 34 34 34
免税店向け
Small gasket
Large gasket
(When odors remain in the rice cooker)
2
3
Steam
cap
O-ring
Clean the inner pot, inner lid,
and steam cap with a standard
kitchen detergent, and then
rinse sufficiently with water.
Allow the rice cooker and all
parts to dry in a well ventilated
location.