Reheating Cooked Rice - Tiger JKT-D10U Mode D'emploi

8

Reheating Cooked Rice

For piping hot rice, reheat the rice that is being kept
warm before serving it.
Note
● Rice will not be fully heated if more than half of
the inner pot is full.
● The rice will end up being dry if reheated under
any of the following conditions.
• The rice is still hot, especially immediately after
cooking.
• There is less than the minimum required amount
of rice (1 cup with the 5.5-cup cooker, 2 cups
with the 10-cup cooker).
• The rice is reheated 3 times or more.
1
Stir and loosen the rice that was
being kept warm.
2
Add 1 to 2 tablespoons of water
evenly over the rice.
Tips
● Adding water will prevent the rice from drying out
and result in plumper rice.
3
Make sure that the Keep Warm
lamp is on.
• Reheating is not available if the Keep Warm
lamp is not on. If the lamp is not on, press
the [Keep Warm] key. (See P.22)
On
4
Press the [Start] key.
The Start lamp will blink and
reheating will start.
The remaining time will be
displayed and the rice cooker will
beep 3 times (long beeps) when
the operation is complete.
• To stop reheating, press the [Cancel] key.
• Reheating is not available if the rice is too
cold (131°F [55°C] or lower as a guideline).
In this case, a repeated beeping alarm will
sound.
5
Stir and loosen the reheated
rice well, and even it out in the
inner pot.
Blinks
23 23
免税店向け