Placing A Pipe Closer; Completing The Installation - WANDERS Norma Mode D'emploi Et Instructions D'installation

Placing a pipe closer
For natural gas:
With 1 metre vertical and wall duct of Ø 70 mm
With 1 metre vertical and 1, or  metres vertical: no
pipe closer
With a roof duct without bend you must place:
• A pipe closer of Ø 50 mm from  to 4 metres
• A pipe closer of Ø 40 mm from 5 to 10 metres
Place the pipe closer by screwing it on the inside below
the mouth of the pipe. See the illustration.
For propane
With a wall duct: no pipe closer
With a roof duct without bend you must place:
• A pipe closer of Ø 50 mm from  to 4 metres
• A pipe closer of Ø 40 mm from 5 to 10 metres
Place the pipe closer by screwing it on the inside below
the mouth of the pipe. See the illustration.
Completing the installation
The concentric system is now fitted and the hearth is
installed. To complete the installation, the following
must be carried out:
Opening the door
The gas fireplace must be ignited only when the door
is closed. The door is locked for safety reasons. You can
open the door by turning the screw clockwise. Once the
door is open you can place the ceramic lumber set.
Photograph: Remove ornamental frame
• Unscrew the two cross-slotted screws and lift the glass
pane.
• PLEASE NOTE: Be sure not to touch the cleaned glass
6
with your fingers when you replace the pane. Finger
marks burn in the glass.
Placing the ceramic lumber set (only
for natural gas)
• How to open the door is explained on page 18
• Place some pieces of ceramic bark exactly as shown
in the illustrations. Start with four pieces of bark on
the burner but do not block the outflow passage of the
pilot.
• Place the ceramic logs exactly as shown in the
illustrations. This will give regular flames and prevents
soot build-up.
• Place the rest of the bark in the empty spaces around
the logs. Do not place them on the burner.
• PLEASE NOTE: Be sure not to touch the cleaned glass
with your fingers when you replace the pane. Finger
marks burn in the glass.
• Do not forget to replace the door correctly and close
it before lighting the hearth.